东芝2006打印机显示请求维修c413
更新时间:2024/4/4 19:00:41,view:60东芝2006苏州东芝渭塘打印机维修服务中心电话0512-696l6769,苏州东芝2006渭塘维修站,东芝2006渭塘维修站, 东芝c452维修代码, 东芝2309出粉量调整, 东芝2508 f101, 东芝打印机c449请求维修, 东芝打印机c449请求维修是什么原因,
东芝2006 陶钣羞 2018-12-19苏州园区东芝维修站电话-696l6769
Code C413
Description Fuser unit related service call. Thermistor abnormality during warming up or in ready status after abnormality judgment.
Causes MAIN board Thermistors Heater lamp
Remedy
1 Check the power voltage Check if the power voltage is normal. (Is the voltage during the operation ±10% of the rated voltage?)
2 Check the each elements of error status Check the abnormal thermistors 08-4570-0: Center thermistor 08-4570-1: Side thermistor 08-4570-2: Edge thermistor 08-4570-5: Error counter
3 Check the thermistors
1. Check if the connectors are disconnected.
2. Check if the center and edge thermistors are in contact with the surface of the fuser roller properly?
3. Check if the center and edge thermistors are not deformed or dirty.
4. Check if the harnesses of the center and edge thermistors are open circuited.
4 Check the heater
1. Check if the heater is broken.
2. Check if the connector of the heater is disconnected.
3. Check if the harnesses are connected properly to the terminals of the heater lamp.
4. Check if the thermostat is blown.
5 Check the MAIN board
1. Check if the connectors are disconnected.
2. Check if the conductor pattern on the MAIN board is short circuited or open circuited.
3. Replace the MAIN board.
热门图文