佳能2002g打印机出现错误代码e014-0000
更新时间:2024/4/24 1:43:49,view:807佳能2002g苏州佳能打印机售后维修服务中心电话0512-696l6769,苏州佳能维修点电话, 佳能8300打印机报错404E, 佳能支持代码6000, 佳能MG2400不往下走纸, 佳能2420提示添加纸张, 佳能2900打印出白纸然后显示缺纸,
定影马达错误-马达启动之后,在2 秒或更长时间之内没有检测到锁定状态。定影马达上超过负荷。
对 策: 关闭主电源再将其打开。
E014原因
定影马达 (M11)断路或接触不好。直流控制器印刷电路板故障。
注意 1:
如果机器显示在 E000 到 E003 的范围,关机重启以后无法复位错误,需要执行下列维修模式项:COPIER>FUNCTION>CLER>ERR。
注意 2:
如果机器出现的错误是定影辊使用值达到上限。更换定影组件或定影上辊,执行下列维修模式项:COPIER>COUNTER>MISC>FX-UP-RL。
注意 3:
如果更换了直流控制器印刷电路板或初始化了直流控制器上的随机存储器,确保在下列维修模式项中输入在更换或初始化之前的读取值:
COPIER>COUNTER>MISC>FX-UPRL。
注意 4:
当定影上辊计数器的读取值达到 100000 时,机器会发出一个警告。佳能2002g打印机出现错误代码e014-0000 佳能2002g 李碑谄 2018/11/17 17:33:16苏州市佳能维修站电话-696l6769
出现错误代码e014-0000 ,Code E014-000
Description After the fixing motor drive signal is generated, the clock signal does not arrive within1.3 sec
Causes The fixing motor (M19) is faulty. The DC controller PCB is faulty.
Remedy
1. Connector Is the connector of the fixing motor connected? NO: Connect the connector.
2. Main power supply PCB Is the drive voltage (24 V) of the fixing motor supplied by the main power supply PCB? Main power supply PCB: between J202-3 (24VU1-S) and J202-4 (OVU1) NO: Replace the main power supply PCB.
3. Fixing motor (M19), DC controller PCB Press the Start key. Is the lock signal of the fixing motor present at the connector (J312) on the DC controller PCB? Lock signal: J312-B4 (FSRM_LOCK*) the DC controller PCB change from 0 to about5 V? YES: Replace the fixing motor. NO: Replace the DC controller PCB.
热门图文